Canon CXDI-80C Service Manual page 59

7.1.7 Connecting to the X-ray interface box
(1) Removing the covers
1) Remove the two screws of each of the two side panels (a total of four screws) and the two screws on
the bottom panel of the X-ray interface box.
* Take care not to strip the screw heads of the side panel and bottom panel.
X-ray interface box
2) Slide the top cover toward the connector connection side of the X-ray interface box, and raise it to
remove it.
* Do not tilt the top cover too far since this may cause the inside of the X-ray interface box to be
damaged.
3) Remove the top cover. The box now looks like what is shown in the figure below.
2. Installation procedures
- 26 -