Storing The Rotatrac Egft 8000; Preservation - Bosch Rexroth ROTATRAC eGFT 8000 10 Series Manual

24/64 Transport and storage
Bosch Rexroth AG, ROTATRAC eGFT 8000 general operating instructions series 10, RE 79088-01-B/02.2019
 Carefully attach the planetary gearbox with approved lifting equipment, such as
chains and shackles adapted to weight, suitable ropes or eye bolts (see
illustration on the left) to the crane hook or transport the planetary gearbox in a
suitable transport frame using a suitable forklift.
Choose the chain or cable length such that the attachment angle remains smaller

than 90°.
Please ensure that the mounting parts attached depending on the gearbox

design cannot be damaged by transport elements when the planetary gearbox is
lifted.
Always load the planetary gearbox on a load-bearing surface as shown in the

figure beside.

6.2 Storing the ROTATRAC eGFT 8000

Risk of damaging the planetary gearbox!
A planetary gearbox stored for more than 12 months has to be thoroughly
inspected and submitted to a test run before use!
If necessary, contact our Rexroth Service before installing a planetary gearbox

that has been stored for more than 12 months.
 This product should only be tested by qualified personnel (refer to chapter
2.4 "Qualification of personnel").
Preservation and storing of the planetary gearbox is described in this chapter.
For queries concerning preservation and storage, please contact a Rexroth's
subsidiary located near you or the main plant directly. For the addresses of our
national agencies, refer to www.boschrexroth.com/addresses and the address
directory in appendix A "Address directory" of the material number-specific
operating instructions.

6.2.1 Preservation

Rexroth delivers the planetary gearbox without oil filling. The planetary gearbox is,
however, preserved from the inside with e.g. Ri Chan Jia HE L-HL15.
The external flange surfaces and flanging surfaces are applied with preservative by
the factory (e.g. PERIGOL VCI 230 or CUSTOS 10-38).
After removing the packing, you must check whether the outside preservation is still
correct.
 If the preservation is damaged and gearbox parts on the outside have bright
spots, then preserve these spots again with e.g. PERIGOL VCI 230 or CUSTOS 10-
38.
NOTE