Bosch Rexroth ROTATRAC eGFT 8000 10 Series Manual page 33

7 Align the electric motor and the planetary gearbox to each other (use the
threaded rods as a guide) as it should be screwed together when installed (see
Fig. 4).
8 Turn the drive shaft of the electric motor so that a tooth gap is congruent with
the mark on the motor flange.
9 Now push the motor onto the gears of the drive shaft of the planetary gearbox.
10 Use 2x motor fastening scews 3 to fasten the electric motor to the planetary
gearbox. Tighten the motor fastening screws with a torque wrench. Take the
tightening torques from the spare parts drawing in appendix D "Technical data /
Drawings" of the material number-specific operating instructions.
11 Remove the 4x threaded rods on the planetary gearbox and replace them with 4x
engine mounting screws 3. Tighten the motor fastening screws with a torque
wrench. Take the tightening torques from the spare parts drawing in appendix D
"Technical data / Drawings" of the material number-specific operating
instructions.
12 Remove all means of attachment, transport and lifting equipment.
13 Connect all power units and mounting parts required for operation of the
planetary gearbox. For this, observe the instructions in chapter 7 "Assembly".
RE 79088-01-B/02.2019, ROTATRAC eGFT 8000 general operating instructions series 10, Bosch Rexroth AG
Assembly 33/64