Table of Contents
Advertisement
Danger of delayed holding of the static multiple-disk parking brake!
The delayed application of the static multiple-disk brake may cause the vehicle to
roll away accidentally.
Make sure that the brake line of the static piston is not pressurized within 0.5
seconds.
To connect the static multiple-disk parking brake to the hydraulic system:
Procedure
1
Make sure that the installation point is free of dirt and foreign substances. Make
sure that neither dirt nor foreign substances penetrate in the brake release
connection. The brake release connection is shown and labelled in the planetary
gearbox dimensioned drawing in appendix D "Technical data / Drawings" of the
material number-specific operating instructions.
2
Remove the screw plug on brake release connection 6 of the planetary gearbox.
3
Connect the brake release line to the brake release connection 6.
4
Connect the static multiple-disk parking brake according to the hydraulic diagram
of the machine or vehicle manufacturer with the remaining hydraulics system.
RE 79088-01-B/02.2019, ROTATRAC eGFT 8000 general operating instructions series 10, Bosch Rexroth AG
WARNING
Assembly
35/64
Advertisement
Table of Contents
