Table of Contents
Advertisement
22/64
About this product
1
2
3
4
Bosch Rexroth AG, ROTATRAC eGFT 8000 general operating instructions series 10, RE 79088-01-B/02.2019
You may set the bores 8 and 9 in the cover of the planetary gearbox to different
positions by turning the ring gear. The positioning of the bores 8 and 9 to each
other remains however fixed. Fig. 1, view B shows the possible position of the
cover only in an exemplary manner. For the exact arrangement, refer to the
planetary gearbox dimensioned drawing in the appendix D "Technical data /
Drawings" of the material number-specific operating instructions. In the chapters
8.1.3 "Filling the planetary gearbox with lubricating oil", 10.2.2 "Checking the oil
level of the planetary gearbox" and 10.4.2 "Changing the lubricating oil", the
cover is shown in the required position.
The indicated gear type is an example. Your ROTATRAC eGFT 8000 planetary
gearbox may differ from this example in the following points:
• Position and type of the connections
• Position of oil filler opening
• Position of the oil level control system
• Position of the oil drain opening
• Position and type of mounting parts
•
Optional
wheel stud
•
Optional
disconnect mechanisms (deactivation)
5.6 Identification of the product
A name plate is located on the planetary gearbox, enabling you to identify the
product.
5.6.1 Standard name plate
The following information is indicated on the name plate:
Fig 2:
Example of a planetary gearbox name plate
1 Manufacturer
2 Type code
3 Factory specific order number
4 Serial number
The name plate shown above is only an example of the Rexroth name plate. In
addition, the serial number is engraved on the gearbox housing. For this
information, please refer to the front side/motor connection side on the spindle.
5
6
7
8
5 Internal factory code
6 Ratio of the gearbox
7 Date of manufacture
8 Product material number
Advertisement
Table of Contents
