Installing The Planetary Gearbox; Scope Of Supply) - Bosch Rexroth ROTATRAC eGFT 8000 10 Series Manual

30/64 Assembly
Procedure
Bosch Rexroth AG, ROTATRAC eGFT 8000 general operating instructions series 10, RE 79088-01-B/02.2019
7.5.2 Installing the planetary gearbox (the electric motor is not included in the

scope of supply)

Failure or damage to the planetary gearbox!
If you install the planetary gearbox in any other installation position than the one
permitted by Rexroth, the planetary gearbox may be damaged or fail. The warranty
claim lapses!
Only install the planetary gearbox in an approved Rexroth mounting position as

indicated in the dimensioned drawing in appendix D "Technical data / Drawings"
of the material number-specific operating instructions.
 Observe the operating instructions of the electric motor manufacturer (not
included in the scope of supply). This is where you will find all the required
information on assembly and commissioning of the electric motor.
If the planetary gearbox is delivered without the electric motor, install as follows:
• Assemble the planetary gearbox to the machine or chassis frame.
• Then assemble the electric motor to the planetary gearbox
Risk of damaging the planetary gearbox!
Incorrect installation of the electric motor may damage the shaft seal on the drive
shaft of the planetary gearbox!
 Avoid an excessive misalignment of the drive shaft when installing the electric
motor.
Avoid any radial forces on the drive shaft.

Before installing the planetary gearbox in the machine or vehicle frame, proceed

as described below.
Assembling the planetary gearbox at/in the machine or chassis frame.
1 For installation, strictly observe the corresponding data in the dimensioned
drawing of the planetary gearbox in appendix D "Technical data / Drawings" of
the material number-specific operating instructions.
2 Also observe the primary operating instructions of the machine or vehicle and the
manufacturer's frame drawing.
3 For the planetary gearbox weight, refer to appendix D "Technical data /
Drawings" of the material number-specific operating instructions.
4 Transport the planetary gearbox to the application machine.
5 Make sure that the surface is stable.
6 Place the planetary gearbox with the cover plate down on two suitable squared
timbers. Secure the planetary gearbox against tipping over.
CAUTION
NOTE