Use caution when removing the server as the current rails do not have "stops." Two
people should be available to unmount and move the unit.
6. Place the server on a level work surface such as a table or cart.
7. Using the #1 Phillips screwdriver, remove and set aside the two (2) MFB retaining
screws.
8. Without lifting the MFB, slide the MFB towards the rear of the server, as shown in
the next illustration.
The MFB should slide approximately 2 to 2.5 inches (5 to 7 centimeters), creating a
gap between the MFB and the top front of the chassis.
Looking into the gap, you will see six (6) cables connecting the MFB to the rest of the
server. A cable tie is used to secure each cable.
Chapter 6: Replacing server components
Hitachi NAS Platform 3080 and 3090 G2 Hardware Reference
Replacing the FPGA board
66