Zone Indicators - Haier Ampac ZoneSense PLUS Operation Instructions Manual

FAULT
Fault – Amber Is a general fault indicator that flashes if a fault is present on any part of the
system.
ISOLATED
Isolated – Amber Is a general isolate indicator that is illuminated if a Zone, Bell, Warning
System or ACF is isolated.
EXTERNAL
ALARM
ISOLATE
External Bell Isolate – Amber Illuminated by the isolation of the "External Bell" output. This
indicator is integral with the "External Bell Isolate" button.
WARNING
SYSTEM
ISOLATE
Warning System Isolate – Amber Illuminated by the isolation of the 'Warning System"
output. This indicator is integral with the "Warning System Isolate" button.

3.3 Zone Indicators

There are two indicators for each alarm zone fitted to the panel.
1. Zone Alarm – Red The indicators show individual zone/s in alarm. On alarm the LED will flash
until the alarm is acknowledged. Once acknowledged the LED will be continuously illuminated
until the panel is reset.
ZONE 1
ZONE 3
ZONE 5
ZONE 7
2. Zone Fault / Isolate – Amber
Illuminated by;
➢
a fault condition on an individual zone (flashing);
➢
isolating a zone/s, illuminated steady unless in fault, then flashes.
A zone in fault that has already been isolated flashes at a different rate than when only in fault, the off
period is the same with the on period being 3 times that of the fault flash rate.
ALARM
ZONE 2
ZONE 4
ZONE 6
ZONE 8
FAULT / ISOLATE
8 ZONE FACP
ALARM
ZONE 1
ZONE 3
FAULT / ISOLATE
4 ZONE FACP
MAN1564-3
ZONE 2
ZONE 4
9