Table of Contents
Advertisement
LUNA2000-100KTL-M1 Smart Power Control System
User Manual
● The cable outer diameter can be measured using the ruler sticker in the
● If a cable has a jacket, ensure that the jacket is in the maintenance
● Ensure that the AC power cables are connected securely. Otherwise, the Smart
● Do not pull the cables horizontally after they have been secured, as this may
Precautions
Step 1 Prepare the cables. For details, see
Step 2 Remove a rubber ring based on the cable diameter range. Cut off the joints
between rubber rings using scissors and then remove the rubber ring. All rubber
rings are removed in the same way.
Figure 5-8 Removing a rubber ring
Step 3 Connect the AC power cables to the terminal block and ensure that the cables are
securely connected.
Issue 07 (2023-07-15)
NO TICE
maintenance compartment.
compartment.
PCS may fail to operate, or be overheated in operation due to unreliable
connection, which will damage the terminal block.
damage the wiring terminals.
NO TE
Remove a rubber ring strictly based on the cable diameter range and ensure that the
crimping module is not damaged. Otherwise, the ingress protection (IP) rating of the device
will be affected.
Copyright © Huawei Technologies Co., Ltd.
A Crimping an OT or DT
5 Electrical Connections
Terminal.
44
Advertisement
Table of Contents
