Table of Contents
Advertisement
Chapter 2 Useful Features
5. Press the <F10> key to set Select Configurable Array(s), and then press the <Space> key.
SPAN-1 is set.
6. Press the <F10> key to create a Virtual Drive.
The Virtual Drives Configure screen appears. (The figure below shows an example of
RAID1 configured with two physical devices. xxx.xxxGB shows the
capacity.)
7. Select a relevant value for RAID, Units, Size, DWC, RA, and Span by using cursor keys.
Press the <Enter> key to fix the selection to determine each value.
(1)
RAID: Specify the RAID level.
Parameter
0
1
10
The selectable RAID level varies depending on the number of physical devices that configure the
disk array.
Important
Select Configurable Array(s)
A-0
SPAN-1
Virtual Drive(s) Configured
VD
RAID
Size
0
1
xxx.xxxGB
Virtual Drive 0
RAID = 1
Units = MB
Size
= xxxxxxMB
DWC
= Off
RA
= On
Accept
SPAN = NO
Remarks
RAID0
RAID1
RAID10
Screen for RAID5 may appear, but this server does not support RAID5.
Express5800/R120f-1E Maintenance Guide
5. RAID System Configuration
#Stripes
StripeSz
2
64 KB
Status
ONLINE
125
Advertisement
Table of Contents
