NEC EXP803 Maintenance Manual page 182

Chapter 3 Appendix
Error Message
9040 PEI_CPU_SELF_TEST_FAILED
9041 Detected CPU Error on CPU #1
9042 Detected CPU Error on CPU #2
9060 PEI_CPU_MISMATCH
9080 Link in Slow Speed Made
between CPU1 and CPU2.
9081 Link Failure between CPU1
and CPU2
9082 Link width Error between
CPU1 and CPU2
9E80 Forced to use CPU with
error.
A001 Memory Error detected in
CPU1_DIMM1
A002 Memory Error detected in
CPU1_DIMM2
A003 Memory Error detected in
CPU1_DIMM3
A004 Memory Error detected in
CPU1_DIMM4
A005 Memory Error detected in
CPU1_DIMM5
A006 Memory Error detected in
CPU1_DIMM6
A007 Memory Error detected in
CPU1_DIMM7
A008 Memory Error detected in
CPU1_DIMM8
A00D Memory Error detected in
CPU2_DIMM1
A00E Memory Error detected in
CPU2_DIMM2
A00F Memory Error detected in
CPU2_DIMM3
A010 Memory Error detected in
CPU2_DIMM4
A011 Memory Error detected in
CPU2_DIMM5
A012 Memory Error detected in
CPU2_DIMM6
A013 Memory Error detected in
CPU2_DIMM7
A014 Memory Error detected in
CPU2_DIMM8
Online Spare Memory was not
A420
ready.
Mirroring Memory was not
A421 ready.
Lockstep was not ready.
A423
182
Cause
An error was detected in CPU
initialization.
An error was detected on CPU #1.
An error was detected on CPU #2.
CPU #1 and #2 are not the same
type.
Low-speed mode was detected on
bus between CPU1 and CPU2.
Connection failure was detected on
bus between CPU1 and CPU2.
Connection decline was detected on
bus width between CPU1 and
CPU2.
An error was detected in CPU, but
the CPU was forcedly enabled.
An error was detected in
CPU1_DIMM1.
An error was detected in
CPU1_DIMM2.
An error was detected in
CPU1_DIMM3.
An error was detected in
CPU1_DIMM4.
An error was detected in
CPU1_DIMM5.
An error was detected in
CPU1_DIMM6.
An error was detected in
CPU1_DIMM7.
An error was detected in
CPU1_DIMM8.
An error was detected in
CPU2_DIMM1.
An error was detected in
CPU2_DIMM2.
An error was detected in
CPU2_DIMM3.
An error was detected in
CPU2_DIMM4.
An error was detected in
CPU2_DIMM5.
An error was detected in
CPU2_DIMM6.
An error was detected in
CPU2_DIMM7.
An error was detected in
CPU2_DIMM8.
Memory Sparing feature is disabled
in this memory configuration.
Memory Mirroring feature is
disabled in this memory
configuration.
Memory LockStep feature is
disabled in this memory
configuration.
Express5800/R120f-1E Maintenance Guide
1. POST Error Message
Solution
Contact your sales representative.
Confirm the setting for Memory RAS Mode in
SETUP. If Memory Sparing, Memory
Mirroring, or memory LockStep feature is
enabled and DIMM is degraded, this POST
error is displayed.
Run SETUP, change parameter for Memory
Retest to Yes, and then perform Save
Changes and Exit.
If the same error persists, contact your sales
representative.