Toshiba LF620F Instruction Manual page 63

Note 1: If COUNT, RANGE, GRAPH or CUSTOM is selected, the display is shown below:
COUNT: displays the totalized flow counts (up to 8 digits).
RANGE: displays the range number being used for measurement (1 to 4).
GPARH: displays the measured value (% value) in bar graph.
CUSTOM: displays the result obtained by multiplying m
Note 2: GRAPH display can be selected only for Display 2 screen.
Note 3: Mgl=1,000,000 gal.
Note 4: Please do the unit setting of the HART communication by the HART communication.
For display settings, Display 1 (DSPL1) and Display 2 (DSPL2) can be set independently.
The following is an example to change the Display 1 setting from % to mL/s.
Switch operation
STEP1
STEP2
STEP3
STEP4(=END)
Note 1: The first unit (volumetric units etc.) changes as shown below:
3
% m
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
In addition, the range number being used for measurement is also displayed.
The details see 10.10 "Custom unit function".
Display example
B:DISPLAY
1 DSPL1
2 DSPL2
3 CS VAL
4 CS UNIT
5 EXIT
ESC
DSPL1
%
ESC
DSPL1
%
DSPL1
mL/s
DSPL1
mL/s
SET OK?
O K
ESC N O
L mL bbl
－ 62 －
3
/min by the custom coefficient.
Description
Select "DSPL1" from the setting item
selection menu.
The currently set display setting (% in this
example) appears.
Then push .
* Pushing returns you to the setting
ESC
menu.
The switches at the bottom change.
(
At the same time, the cursor appears.
Push to move the cursor from the
second unit to the third unit and change the
display unit by pushing
Repeat this operation to change the display
unit to mL/s.
When the desired display unit is selected,
push to set the display unit
temporarily.
Pushing shows a message to confirm
whether the setting is OK or not.
If OK, push O K
. If you need to redo
the setting, push .
N O
Pushing cancels the setting
ESC
operation and exits the setting screen.
gal m/s ft/s
6 F 8 A 0 9 2 8
are shown.)
.