Toshiba LF620F Instruction Manual page 99

Operation when fixed output is set to ON
Current output
Pulse output
Digital output other than
pulse output
Display
Display example:
* 1 0 0 0 0
*
First line:
Second line: Current output (4 digits including a decimal point), Unit: (mA) fixed
This fixed value output function does not work in the calibration mode.
When OFF is selected in the fixed output function, the setting for output is not needed.
●Changing the fixed output function
The following procedure shows how to set the fixed output to ON and set the fixed current
value/fixed pulse value. The fixed current value and fixed pulse value can be set
independently.
Switch operation
STEP1
STEP2
STEP3
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Output is the fixed current output value.
Output is the fixed pulse rate pulse signal.
Status in hold
Display 2 screen: Used to indicate the fixed output
(Note)
P P S *
2 0 . 0 m A
Pulse count (5 digits maximum), Unit: (PPS) fixed
Display example
O:FIX OUT
1 FIX SET
2 CUR VAL
3 PLS VAL
4 EXIT
ESC
FIX SET
OFF
ESC
FIX SET
OFF
FIX SET
ON
－ 98 －
*
Description
Select "FIX SET" from the setting item
selection menu.
The current setting (OFF in this example)
appears.
Then push .
* Pushing returns you to the menu
ESC
screen.
The switches at the bottom change.
(
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push
You can continue to change the setting item.
Push to change the selection
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
When the desired item is selected, push
to set the item temporarily.
6 F 8 A 0 9 2 8
are shown.)
.