Advertisement
6
2.2 Power supply connection and requirements
Connect Power Supply (user supplied): 24 V DC via 3-pin Terminal
Current Consumption from Power Supply (Max.): 340 mA
The following Power supply will mount on the same DIN Rail as the gateway and provide the required 340mA:
ABB 1SVR427041R0000, CP-D 24/0.42
If additional power or other features are needed, additional ABB Power Supplies are available at
new.abb.com/low-voltage/products/power-supplies
CAUTION!
Risk of damaging the VFD-GATEWAY! Make sure that the supply voltage never exceeds 30 VDC
Safety Extra Low Voltage (SELV) and Protective Extra Low Voltage (PELV)
To ensure electrical safety of VFD-GATEWAY extra low voltage circuits, 24 V DC supply, communication interfaces, I/O
circuits, and all connected devices must be powered from sources meeting requirements of SELV, PELV, class 2,
limited voltage, or limited power according to applicable standards.
2.3 Ethernet interface
Connect your Ethernet interface via the VFD-GATEWAY RJ45 jack
Note: EtherNet cable not included. The network cable must be CAT5 or higher, and type UTP, FTP or STP.
The maximum length for an Ethernet segment on twisted pair media is 100 meters.
The VFD-GATEWAY supports twisted pair as the physical media in a star topology. All twisted pair media between the
Ethernet node and the switch or router must be shorter than 100 meters, including media within patch panels.
Activity
Link
LED
Color
Activity
Yellow
Link
Green
Off
On
No Activity
-
No Link
Link
Flashing
Activity
-
LVD-EOMU02U-EN REVD 11/2022
Advertisement
