Assembling The Sausage Stuff Er Attachment - Silvercrest SFW 250 B1 Operating Instructions Manual

GB
Assembling the sausage stuff er attachment
6
5) Place your selected cutting disc
the indentation on the cutting disc 9 lies on the securing fi tment in the meat
grinder casing 5.
6) After everything has been correctly assembled, screw the ring clamp
back on hand-tight.
7) The ready-assembled meat grinder casing
connector to the motor block 4:
– Insert the meat grinder casing
arrow on the feeding shaft lies against the symbol
block 4. The locking button presses itself in. (Fig.
– Lightly press the meat grinder casing
the feeding shaft on the meat grinder casing 5 into the middle position
(Fig. ) so that the arrow on the feeding shaft points to the symbol
When the meat grinder casing 5 engages, the locking button springs
out.
– Finally, place the feed tray
– To dismantle it, press the locking button and turn the feeding funnel to
the right (Fig.
Unfold the fold-out side - there you will fi nd the step-by-step illustrations for as-
sembling the appliance.
1) Remove the meat grinder casing
meat grinder".
2) Disassemble any attachments that might be fi tted and clean the meat grinder
casing 5.
NOTICE
► For the sausage stuff er attachment
7 is not required! If need be, remove them both from the meat grinder
casing 5.
3) Coat all metal parts with cooking oil.
4) Take the sausage disc
(Fig. ).
5) Insert the sausage disc
lies on the securing fi tment in the meat grinder casing 5.
6) Then place the sausage stuff er attachment
7) Screw the ring clamp
8) Assemble the meat grinder casing
meat grinder".
9 into the meat grinder casing 5 so that
5 is connected by a bayonet
5 into the motor block 4 such that the
5 in and at the same time turn
3 on top of the feeding funnel.
. You can now pull the meat grinder casing 5 out.
)
5 as described under "Assembling the
q, the cross blade 8 with the spring
w from the small compartment of the appliance
w so that the indentation on the sausage disc w
q before the sausage disc w.
0 on hand-tight.
5 as described under "Assembling the
0
on the motor
).
.
SFW 250 B1