Meter Size - Toshiba LF620 Instruction Manual

Switch operation
STEP6
STEP7(=END)
Note: The setting range of excitation current value is from 0.0000A to 0.2500A.
If you try to set an exciting current value larger than 0.2500A, an error message appears
and the setting value returns to the previous value.

8.2.3 Meter Size

Proceed as follows to check or change the meter size of the detector.
Switch operation
STEP1
STEP2
STEP3
Display example
EXC CUR
0.2150
A
SET OK?
ESC O K
EXC CUR
0.2150
O K
A
ESC
Display example
A:DETECTOR
1 EXC CUR
2 SIZE
3 EXC FREQ
4 FLOW DIR
5 EXIT
ESC
SIZE
mm
ESC
SIZE
mm
SIZE
65
mm
Pushing
the setting is OK or not.
If OK, push
setting, push
Pushing
ESC
and exits the setting screen.
N O
When you push
message, the set value is fixed.
Then pushing
setting menu. If you push
change the current value from 0.2150A
again.
Select "SIZE" from the setting item
selection menu.
The currently set meter size (50mm in this
example) appears.
50
Then push
Pushing
ESC
menu.
The switches at the bottom change.
(
50
At the same time, the cursor appears.
(The item indicated by the cursor is
highlighted.)
Then push
You can continue to change the setting
value.
Push
items.
: Selected item is scrolled up.
: Selected item is scrolled down.
− 56 −
6 F 8 A 0 9 2 7
Description
shows a message to confirm
. If you need to redo the
O K
.
N O
cancels the setting operation
to "SET OK?"
O K
brings you back to the
ESC
, you can
Description
.
returns you to the setting
are shown.)
.
to change the selection