Configuration Items Selection Table - Toshiba LF620 Instruction Manual

7.4 Configuration Items Selection Table

How to check or change each constant of the converter is shown in the table below.
Details of each item are described in the setting items (A to R) of Chapter 8, "Parameter Settings."
○ Basic configuration (when menu configuration is BASIC)
When you select "BASIC" in the menu configuration screen, the menu to check or change each
constant is executed as follows.
LOW CUT
When the mode is changed from the measurement mode to the setting mode, Group B is displayed first
in the case of Basic configuration. After that, the screen changes as follows:
Group B (Start screen) ⇔ Group C ⇔ Group D ⇔ Group E
⇔ Group F ⇔ Group H ⇔ Group I ⇔ Group J
Fucntion 1
B
Display1
DISPLAY
C Range
RANGE type
D Damping
FILTER value
E Low cut
Value
Still water
F
zero point
ZERO
adjustment
H Digital
DO output 1
I Digital
DI input
J
Count rate
CNT/PLS
2 3
Returns
Display2 to meas.
mode
Returns
Range1 to meas.
mode
Returns to
meas.
mode
Returns to
meas.
mode
Returns to
meas.
mode
Returns
Digital
to meas.
output 2
mode
Returns to
meas.
mode
Pulse
width Pulse
setting width
mode
− 49 −
6 F 8 A 0 9 2 7
4
Returns to
meas.
mode