Cleaning The Air Outlet And The Panel; Preparation For Extended Non Operation - Zanussi ZS12V70CCHI Service Manual

1. Lift the indoor unit front panel up to an angle until it stops with a full support from the bracket.
Dust filter handle
2. Hold the dust filter handle and lift it up slightly to take it out from the filter holder.
3. hen pull the dust filter downwards out of the indoor unit. Vacuum the dust filters with a vacuum cleaner. If the filters are too dirty,
wash them with warm water and mild detergent. Make sure to dry the filters before re-install them. Do not dry with fire or under
direct sunlight.
4. Insert the upper portion of air filter back into the unit, taking care that the left and right edges line up correctly and place filter into
position.

7.4 Cleaning the air outlet and the panel

1. Use a dry and soft cloth to wipe it.
2. Pure water or mild detergent may be used if it is very dirty.
• Do not use benzine, thinner, polishing powder, or similar solvents for cleaning. These may cause the surface to crack or
deform.
• To avoid the risk of electrical shock or fire, do not let water fall into the indoor unit.
• Never wipe the air flow louver violently.
• Do operate your air conditioner without filter. If your filters are unusable, buy new ones from the authorised service.

7.5 Preparation for extended non operation

If you plan to idle the unit for a long time, perform the following:
1. Clean the indoor unit and filters.
2. Operate the fan for about 15 minutes to dry the inside of the unit.
3. Stop the air conditioner and disconnect power.
4. Remove the batteries from the remote controller. The outdoor unit requires periodic maintenance and cleaning. Do not attempt to
do this yourself. Contact your dealer or service provider.
26