Zanussi ZS12V70CCHI Service Manual page 53

Steps Procedure
18/24K
Evaporator is fixed to the body with 3 screws and 2 pawls. Remove
the 2 screws located on evaporator plastic on the left side the prod-
uct and other screw located on right rear side.
Remove the 2 pawls located on left rear side and right front side.
Move the evaporator pipes towards the right side. Then you can
remove the evaporator by raising.
Removal of fan motor and cross fan
Remove the step motor cable and fan motor cable from the fan
motor cover.
Fan motor cover is fixed to the rear body with two screws. Screw off
these screws with proper tool and remove the cover by raising.
Remove cross flow fan by screwing off the connection screw that
connecting with motor shaft and cross flow fan.
Remove the ring of bearing of sub assy on the cross flow fan.
53