Lubrication; Adding Light Oil Or Spray Lubrication; Greasing The Mower - Toro 74947 Operator's Manual

Lubrication

Grease more frequently when operating conditions
are extremely dusty or sandy.
Grease Type: No. 2 general-purpose lithium-based
or molybdenum-based grease
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings with a rag.
Note:
Make sure that you scrape any paint off
the front of the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins
to ooze out of the bearings.
6. Wipe up any excess grease.
Adding Light Oil or Spray
Lubrication
Service Interval: Every 100 hours
Lubricate the deck lift pivots.
Figure 39
-
EUTRAL LOCK

Greasing the Mower

Service Interval: Every 50 hours—Grease the mower
Important:
spindles are full of grease weekly.
1.
2.
3.
4.
g017028
36
Figure 40
deck spindles and idler arm.
Yearly—Grease the pump belt idler arm.
Yearly—Grease the front caster pivots (more
often in dirty or dusty conditions).
Yearly—Repack the front caster wheel bearings
(more often in dirty or dusty conditions).
Make sure that the cutting unit
Disengage the blade-control switch (PTO), move
the motion-control levers to the
position, and set the parking brake.
Stop the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Grease the mower deck idler pulley pivot until
grease comees out the bottom
For machines with 60-inch decks only, grease
the mower deck idler-pulley pivot until grease
comes out the bottom
g017050
-
NEUTRAL LOCK
(Figure 42).
(Figure 41).