Figure 90
1. Deck-lift pedal
2. Height-of-cut pin
6.
Insert the height-adjustment pin into the 7.6 cm
(3 inches) cutting-height location.
7.
Release the transport lock and allow the deck to
lower to the cutting height.
8.
Raise the discharge chute.
9.
On both sides of the deck, measure from the
level surface to the front tip of the blade (Postion
A) as shown in
Figure
Note:
The measurement should read 7.6 mm
(3 inches).
g027343
3. Transport lock
91.
1. 7.6 cm (3 inch) at position
A is correct
2. 8.3 cm (3-1/4 inch) at
position B is correct
10.
Fine-tune the adjustment nut on the front deck
lift assembly by turning it
Note:
To increase the height, turn the
adjustment nut clockwise; to decrease, turn
counterclockwise.
Note:
If the front deck links do not have enough
adjustment to achieve accurate cut height, the
single-point adjustment can be utilized to gain
more adjustment.
63
Figure 91
3. Measure here from the
blade tip to the hard
surface
4. Measure at position A and
B on both sides
(Figure
92).
g009196