Servicing The Fuses - Toro 74947 Operator's Manual

Installing the Battery
Note:
Position the battery in the tray with the terminal
posts opposite from the hydraulic tank
Figure 59
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity). This is especially
important to prevent battery damage when the
temperature is below 0°C (32°F).
1. Charge battery for 10 to 15 minutes at 25 to 30
A or 30 minutes at 10 A.
2. When the battery is fully charged, unplug
the charger from the electrical outlet, then
disconnect the charger leads from the battery
posts (Figure 60).
3. Install the battery in the machine and connect
the battery cables; refer to
(page 47).
Note:
Do not run the machine with the battery
disconnected, electrical damage may occur.
(Figure 58).
g032526
Installing the Battery
47
Figure 60
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check the
component/circuit for a malfunction or short.
1. The fuses are located on the console to the right
of the seat (Figure
2. To replace the fuses, pull out on the fuse to
remove it.
3. Install a new fuse
Figure 61
1. Optional accessory (15 A)
2. Charge (25 A)
3. PTO (10 A)
3. Red (+) charger lead
4. Black (-) charger lead
61).
(Figure 61).
4. Main (25 A)
5. Console
g000960
g024354