Drive System Maintenance; Checking The Seat Belt; Checking The Rollover Protection System (Rops) Knobs; Adjusting The Tracking - Toro 74947 Operator's Manual

Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of retractor and buckle. Replace the seat
belt if it is damaged.
Checking the Rollover
Protection System (ROPS)
Knobs
Service Interval: Before each use or daily
WARNING
To avoid injury or death from rollover: keep
the roll bar in the fully raised locked position
and use the seat belt.
Ensure that the seat is secured to the
machine.
Check that both the mounting hardware and the knobs
are in good working condition. Make sure that the
knobs are fully engaged with the roll bar in the raised
position. The upper hoop of the roll bar may need
to be pushed forward or pulled rearward to get both
knobs fully engaged (Figure 62).
1. ROPS knob (locked
position)
2. Pull the ROPS knob out,
and rotate it 90 degrees to
change the roll bar position

Adjusting the Tracking

1. Disengage the blade-control switch (PTO).
2. Drive to an open flat area, move the
motion-control levers to the N
position.
3. Move the throttle midway between fast and slow.
4. Move both motion-control levers all the way
forward until they both hit the stops in the T-slot.
5. Check which way the machine tracks.
•
If it tracks to the right, loosen the bolts and
adjust the left stop plate rearward on the
left T-slot until the machine tracks straight
(Figure 63).
•
If it tracks to the left, loosen the bolts and
adjust the right stop plate rearward on the
48
Figure 62
3. Roll bar in the upright
position
4. Roll bar in the folded
position
-L
EUTRAL
g008943
OCK