Replacing The Hydraulic Pump-Drive Belt - Toro 74947 Operator's Manual

1. Clutch pulley
2. Mower belt
3. Spring-loaded idler pulley
4. Ratchet
10. Install the belt guide on the idler arm
11. Using the ratchet in the square hole, install the
idler spring (Figure
Note:
Make sure that the spring ends are
seated in the anchor grooves.
12. Install the belt covers
Figure 79
5. Square hole in the idler
arm for the ratchet
6. Idler-grease fitting
7. Belt guide
(Figure
79).
(Figure 80).
1. Position the belt cover
2. Slide the belt cover under
the side catches
g009038
Replacing the Hydraulic
Pump-Drive Belt
1. Disengage the blade-control switch (PTO) and
engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
79).
3. Remove the mower belt; refer to
Mower Belt (page
4. Raise the machine and support it with jack
stands (Figure
56
Figure 80
3. Ensure that the tab is
under the metal catch
Replacing the
55).
81).
g027730