Checking The End Of The Material - Brother ScanNCut DX Manual

b
While squeezing the adjustment lever, slide the right
guide plate against the roll to correctly align the left edge
of the material.
a Adjustment lever
Note
• The material is correctly loaded when there is a gap of
about 2 to 3 mm between the guide plate and the right side
of the roll. After aligning the left edge of the material, adjust
the guide plate.
a Gap of about 2 to 3 mm
1
1

Checking the End of the Material

Make sure that the end of the material is evenly trimmed to
meet all of the following conditions.
a It must be straight.
b The edges of the material must each come to right angles.
If both 1 and 2 above are not met, it may not be possible to
feed correctly.
Be sure to check before feeding.
11