Evenly Trimming The End Of The Material - Brother ScanNCut DX Manual

a
Pull the end of the material until it reaches the guide
channel.
• Check that the side to be cut faces up.
1
a Guide channel
b Material
b
Make sure the left edge of the material is aligned with the
rolled material guide and the end of the material is
perfectly aligned with the guide channel.
When aligned
●
The end of the material is perfectly aligned. There is
no need to evenly trim the end of the material.

Proceed to the "Attaching the Leader Sheet to
the Material" procedure on page 14, attach the
leader sheet to the material, and place it on the
cutting machine.
1
a Rolled material guide
b Guide channel
c Material
When not aligned
●
The end of the material is not perfectly aligned. The
end of the material must be evenly trimmed.

For details, see "Evenly Trimming the End of the
Material" on page 12.
1
a Rolled material guide
b Guide channel
c Material
12
1 2
2 3
2 3

Evenly Trimming the End of the Material

a
Pull the end of the material until it extends past the guide
channel.
a Guide channel
b
Remove the trimmer from the roll holder.
a Trimmer
c
Install the trimmer over the material.
Align the holes in the trimmer with the pins in the base attachment
as shown below.
1
2
a Hole in trimmer
b Pin on base attachment
d
Align the left edge of the material with the rolled material
guide.
1
a Rolled material guide
1
1
1
2