Table of Contents
Advertisement
Read Before Use
Accessories
After purchasing this kit, check the contents.
A
E
A
Base attachment
B
Roll holder
*1
C
Trimmer
*2
D
Trimmer blade
*3
E
Leader Sheet
F
Activation card for roll feeder function on CanvasWorkspace (Windows/Mac) and 1 free sample design
G
Insertion
*1
This part is attached to the roll holder (B).
*2
This part is attached to the trimmer (C). Do not remove it except when replacing it. If it is removed, see "Installing the Trimmer
Blade" on page 27.
This part is a consumable. When the cutting edge becomes blunt, purchase CADXRFC1 (trimmer blade). Purchase consumables
from the authorized retailer where the roll feeder was purchased.
*3
This accessory is a consumable. If the adhesiveness becomes weak, purchase CADXRFLS1 (Leader Sheet).
Operating Precautions
This attachment was specially designed for the ScanNCut DX model. It cannot be used with any model other than the
●
ScanNCut DX.
In order to use the roll feeder function, the dedicated application CanvasWorkspace (Windows/Mac) must be installed on your
●
computer.
Only rolled material with a width of 305 mm (12") can be used.
●
To use this product, the software on the cutting machine must be updated to Ver. 1.60 or later. If the software you are using is
●
older than Ver. 1.60, download the latest software from the Brother support website (http://s.brother/cuoad/). For details on
updates, refer to the Operation Manual of the cutting machine.
Do not store in a location exposed to direct sunlight, high temperatures or high humidity.
●
To maintain the adhesive strength, attach the protective sheet to the leader sheet after use.
●
Do not bend the leader sheet when storing it.
●
The contents of this document are subject to change without notice.
●
The screens in this manual are for illustration purposes only and may differ from the actual screens.
●
Before beginning, please read the "Useful Information" on page 34.
2
B
F
*1
C
G
Part name
D
Arrangement of packaged
content
Advertisement
Table of Contents
