Attaching The Leader Sheet To The Material - Brother ScanNCut DX Manual

Attaching the Leader Sheet to the Material

a
Pull the tip of the material placed on the roll feeder
toward you.
• Check that the surface to be cut is on the bottom side.
1
a Backing (film)
b
Remove the protective sheet of the leader sheet.
c
Attach the material from above by aligning it straight
along the attachment position line (black line) on the
leader sheet. At this time, align the leader sheet and the
left side edge of the material and stick them together.
a Attachment position line
14
1
Note
• If the left edge of the material is sticking out form the
leader sheet, or the material is attached diagonally to the
attachment position line, it may not feed well.
d
Flip over the leader sheet so that the arrow on the leader
sheet points toward the feeding slot.