Table of Contents
Advertisement
d
Confirm the data, and then touch the "OK" key.
b
a Switch the pattern display.
Select
to display the pattern enlarged to a 12-inch
area.
Select
to display the pattern reduced to show all of it.
b Scroll down through the pattern
c Delete the data
The preview screen appears.
Memo
• When the pattern is displayed reduced, a maximum cutting
length of 1,776 mm (69.9") is displayed, regardless of the
size of the pattern. If the pattern is shorter than 1,776 mm
(69.9"), the pattern will be displayed with space added;
however, cutting will stop at the bottom of the pattern. The
additional space will not be included in the cutting data.
a
c
Cutting
Make sure that the auto blade holder has been installed in
●
the carriage of the machine. For details on the blade holder
that can be used, see "Blades That Can Be Used" on
page 36.
a
Raise the scanner lever (on the left side of the machine) to
"2".
b
Select "Cut" in the preview screen.
• Touch
to confirm the instructions for installing the roll
feeder.
c
To perform trial cutting, touch the "Test" key.
• In order to cut your project properly, perform trial cutting
before cutting the pattern. For details, see "Trial Cutting" on
page 19.
Memo
• When the roll feeder is used, half-cutting is automatically
turned on. Touch
d
see step
in "Changing the cut pressure setting" on
page 20.
to check the settings. For details,
17
Advertisement
Table of Contents
