Table of Contents
Advertisement
d
To perform trial feeding, touch
• For details, see "Trial Feeding" on page 21.
e
To change the cutting start position, touch
• For details, see "Changing the Cutting Start Position" on
page 22.
f
Touch the "Start" key to start cutting.
When cutting is finished, the machine stops at the bottom of
the pattern.
Note
• Before cutting, always make sure that there are no grooves
or objects placed near the ejection slot. The leader sheet
may get caught in a groove or bump against an obstacle,
and may not feed well.
g
To cut off the material at the point where cutting stopped,
select "Finish".
Instructions for feeding the material appear. Confirm the
details, and then touch the "OK" key.
The material is fed until the bottom of the pattern reaches
trimmer on the base attachment.
Memo
• To continue cutting additional patterns without cutting off
the material, select "Continue to cut". For details, see
"Continuous Cutting" on page 23.
Instructions for cutting off the material appear.
• Touch
to confirm the instructions.
18
.
.
h
Install the trimmer over the material.
Align the holes in the trimmer with the pins in the base
attachment.
1
2
a Hole in trimmer
b Pin on base attachment
i
Firmly press the trimmer down on the right side of the
material. While holding them in place, slide the trimmer
blade from right to left to cut off the material.
Slide the trimmer blade while pressing down gently.
• This will create a cut leaving a 10 mm (0.4") margin at the
bottom of the pattern.
• To stop the operation and feed out the material before cutting
it off, press
to feed the material out toward you.
1
a Trimmer
b Trimmer blade
Note
If the material does not cut easily:
• If cutting does not start smoothly, for example, if the
material catches on the blade, instead of sliding the blade
with excessive force, refer to the following and try again.
Sliding the trimmer blade with excessive force may cause
damage.
- If the material is not very pliable, firmly press the
trimmer down on the right side of the material.
- If the material is fairly pliable and has a strong curl,
firmly press the trimmer down at the center.
1
2
2
Advertisement
Table of Contents
