Adjusting Wire Brush; Adjusting Saw Arm - Sharp SW-165HT Instruction Manual

Step 15 - Make sure the sides of the blade are in close contact with the carbide inserts and then
tighten the left and right carbide inserts by
Step 16 – Gently close the idle and drive wheel covers.
Step 17 - Press the saw blade start button to start the blade. Allow the blade to run for a few
rotations then press the saw bow up button to elevate the saw bow. Open the wheel
covers and make sure the blade has not fallen off the drive and idle wheels. If the blade
has shifted, follow the same procedure to reinstall the blade again.
Step 18 - Adjust wire brush to a proper position. Refer to Adjusting wire brush in this section.

ADJUSTING WIRE BRUSH

Follow these steps to adjust wire brush to appropriate position:
Step 1 - Open the drive wheel cover.
Step 2 - Adjust the fixed nuts to make brush move up / down until it makes proper contact with the
saw blade (see below illustration).
Step 3 - Close the drive wheel cover.

ADJUSTING SAW ARM

Adjust the blade guide (guide arm) position based on the size of your workpiece:
Step 1 – Loosen the inserts by unlocking the lock nut.
Step 2 – Loosen the blade guide locking handle. Then adjust the guide arm to a position suitable for
your workpiece size.
Step 3 – After adjustment is made, tighten the blade guide locking handle.
Step 4 – Clamp the inserts back by tightening the lock nut.
4-16
Locking Handle
Inserts Lock Nut
tightening the "lock nut."
Proper Improper