Table of Contents
Advertisement
Gear Oil & Grease Injection Hole :
Grease Injection Nozzle
Gear Oil Injection Hole
Volume window
To unload the waste fluid:
The Screw
Bottom of Gear reducer
STORAGE CONDITIONS
Generally, this machine will be stored on the following conditions in future:
(1) Turn off the power.
(2) Ambient temperature: 5℃ ~ 40℃
(3) Relative humidity:
(4) Atmosphere: use a plastic canvas to cover machine to avoid excessive dust, acid fume,
corrosive gases and salt.
(5) Avoid exposing to direct sunlight or heat rays which can change the environmental
temperature.
(6) Avoid exposing to abnormal vibration.
(7) Must be connected to earth.
1. Put the waste oil container in the bottom of the
.
2. Use the wrench to open the screw for unloading the
3. Make sure the screw bolted tightly after unloading
30%~85%
(without condensation)
1. A grease injection hole and a gear oil injection
hole on the top of gear reducer.
: The position of injection indicating.
2.
Recommend keeping the volume under 50% inside
the vessel of volume window.
*NOTE: Over 50% oil in the gear box
will cause oil spilling out.
3.
To use the machine in a sub-zero
environment, please add antifreeze into gear
reducer.
reducer for unloading waste fluid
waste fluid.
completed,
。
8-5
Advertisement
Table of Contents
