Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Close the Scanner Unit.
Tighten the screw (x1) finally after making sure that there
is no gap between the Scanner Unit and the printer.
Check the gap
Figure 4-11. Installing the Scanner Unit
Make sure to insert the terminal of the Grounding wire to the
fixing rib of the Frame. (See
For the routing of the FFCs, see
(p202).
When installing the Cable Cover, secure it with a new Harness
Cover Clamp. (See
After removing/replacing the Scanner Unit, make the specified
� � � � �
� � � �
adjustments. (See
Chapter 5
�
� � � � �
� � �
DISASSEMBLY/ASSEMBLY
Screw (Final tightening)
Fig.
4-6.)
4.4 "Routing FFC/cables"
Fig.
4-3.)
"ADJUSTMENT".)
Disassembly Procedures
https://www.manualsbooks.com
4.2.2.3 Hinge
Parts/Components need to be removed in advance:
ADF Unit (Artisan 800/PX800FW/TX800FW only)/Scanner Unit
Removal procedure
Remove the screw (x1) that secures the Hinge and remove the Hinge.
1.
Hinge
C.B.P. 3x10 (6±1Kgfcm)(Artisan 800/PX800FW/TX800FW)
C.B.P. 3x12 (black) (6±1Kgfcm)(Artisan 700/PX700W/TX700W)
Figure 4-12. Removing the Hinge
Revision C
105
Confidential