Power Supply Unit - Epson Stylus Photo PX700FW Service Manual

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W

4.2.3.3 Power Supply Unit

Parts/Components need to be removed in advance:
ADF Unit (Artisan 800/PX800FW/TX800FW only)/Scanner Unit/Upper Left
Housing/Paper Guide Top Assy/Upper Housing/Rear Left Housing/Left Housing
Removal procedure
Peel off the PF Encoder FFC from the Power Supply Unit. (See
1.
Disconnect the Power Supply Unit cable from the connector of the Power
2.
Supply Unit. (See Fig. 4-49.)
Remove the screws (x2) that secure the Power Supply Unit, and remove the
3.
Power Supply Unit from the Base Frame.
Power Supply Unit
Figure 4-49. Removing the Power Supply Unit
DISASSEMBLY/ASSEMBLY
Fig. 4-49.)
PF Encoder FFC
Connector
Power Supply Unit cable
Double-sided tape
Rib
C.B.S. 3x6 (8±1Kgfcm)
C.B.P. 3x8 (6±1Kgfcm)
Disassembly Procedures
https://www.manualsbooks.com
Route the Power Supply Unit Cable through the groove of the
Base Frame, then install the Power Supply Unit to the Base
Frame.
Groove of the Base Frame
Figure 4-50. Installing the Power Supply Unit
Install the Power Supply Unit inside the ribs (x2) of the Base
Frame. (See Fig. 4-49)
Be careful not to damage the Power Supply Unit cable by
catching it with the screw when screwing. (See
Secure the PF Encoder FFC to the Power Supply Unit with the
double-sided tape. (See
After removing/replacing the Power Supply Unit, make the
� � � � �
� � � �
specified adjustments. (See
�
� � � � �
� � �
Revision C
Power Supply Unit Cable
Fig. 4-49)
Fig. 4-49)
Chapter 5 "ADJUSTMENT".)
Confidential
121