Rear Frame - Epson Stylus Photo PX700FW Service Manual

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W

4.2.4.18 Rear Frame

The Main Frame becomes unstable once it is removed from the
Base Frame. Be careful not to deform the frame during
performing the following procedures.
◼ Refer to
4.2.4.11 Main Frame (p144)
need to be removed before removing the Main Frame.
Parts/Components need to be removed in advance:
Main Frame/Printhead/CR Scale/Carriage Unit/Front Frame/Ink System/
Transmission Holder Assy
Removal procedure
Deformed antistatic cloth attached on the Rear Frame will cause
ink mist adhering to the print surface; therefore, make sure not to
touch the antistatic cloth.
If it is deformed, make sure to repair it so as to let it touch the paper
as shown in below figure.
Antistatic cloth
Antistatic cloth
Figure 4-143. Position of the antistatic cloth
DISASSEMBLY/ASSEMBLY
for the Parts/Components
No paper
Antistatic cloth must touch the paper.
Paper present
Disassembly Procedures
https://www.manualsbooks.com
1.Peel off the PF Encoder FFC from the Rear Frame. (See
2.Remove the Torsion Spring A (x4), B (x2) and C (x2). (See
3.Remove the Spur Gears (x2) and Combination Gear (x1). (See
Motor Step2 (p152).)
Rear side
PF Encoder FFC
Spur Gear (x2)
Combination Gear (x1)
Figure 4-144. Removing the Rear Frame (1)
Revision C
Fig. 4-144.)
Fig. 4-144.)
4.2.4.15 CR
Torsion Spring A
Rear Frame Torsion Spring B
Torsion Spring C
Double-sided tape
159
Confidential