Cr Motor - Epson Stylus Photo PX700FW Service Manual

Epson Artisan 800/Epson Stylus Photo PX800FW/TX800FW/Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Align the positioning holes (x2) of the Holder with the dowels
(x2) of the Main Frame. (See
Insert the Compression Spring to the dowel of the Tensioner
and attach it to the protrusion of the Tension Holder
reinforcing plate. (See
After removing/replacing the PF Motor, make the specified
� � � � �
� � � �
adjustments. (See
�
After replacing the PF Motor, be sure to perform the required
� � � � �
� � �
lubrication. (See Chapter 6
DISASSEMBLY/ASSEMBLY
Fig. 4-120.)
Fig. 4-119.)
Chapter 5 "ADJUSTMENT".)
"MAINTENANCE".)
https://www.manualsbooks.com

4.2.4.15 CR Motor

The Main Frame becomes unstable once it is removed from the
Base Frame. Be careful not to deform the frame during
performing the following procedures.
◼ Refer to
need to be removed before removing the Main Frame.
Parts/Components need to be removed in advance:
Main Frame
Removal procedure
Loosen the CR Timing Belt, and detach the CR Timing Belt from the Pinion
1.
Gear of the CR Motor. (See
Remove the securing ring that secures the Spur Gear A, and remove the Spur
2.
Gears (A, B) and Combination Gear (x1).
Combination Gear
Spur Gear A
Securing ring
Disassembly Procedures
4.2.4.11 Main Frame (p144) for the Parts/Components
4.2.4.16 Carriage Unit Step2
Spur Gear B
Figure 4-124. Removing the CR Motor (1)
Revision C
- Step4 (p155).)
152
Confidential