Cleaning - Silvercrest 285237 Operating Instructions Manual

1) Remove the handheld vacuum cleaner from the wall bracket
not using the wall bracket
2) If required, place the appropriate nozzle in the suction opening:
–
the crevice nozzle
–
the wet suction nozzle
NOTE
► After you have vacuumed up liquids, immediately clean the dirt container
Otherwise, bacteria or mould will build up inside! Ensure that the dust filter
bag
3) To switch the appliance on, slide the on/off switch
indicator lamp
4) When you have finished using the appliance, slide the on/off switch
the rear.
NOTE
► Place the handheld vacuum cleaner in the wall bracket
charging process once the vacuum power has become noticeably weaker
and the charge indicator lamp

Cleaning

To achieve the best results, empty the dirt container
after every use.
CAUTION! MATERIAL DAMAGE!
► Do not use aggressive, chemical or abrasive cleaning agents. These could
damage the outer surfaces of the appliance.
1) To open the dirt container
dirt container
2) Remove the dust filter
3) Empty the dirt container
4) Pull the dust filter bag
5) Rinse the dust filter bag
dry before reinserting it into the dust filter
6) Reinsert the dust filter
that the dust filter
container
SAS 7.4 LI B2
remove the barrel plug
, to clean narrow and difficult to reach locations.
is completely dry before using the appliance again.
lights up green.
, press the release button
.
from the dirt container
.
with its holder out of the dust filter
out in cold water and wait until it is completely
into the dirt container
is seated squarely and that the rubber lip seals the dirt
.
to vacuum up liquids.
flashes green.
and clean the dust filter
.
. Do not dry it with hot air.
. When doing so, ensure
GB │ IE │ NI │ CY
or, if you are
from the socket.
.
forwards. The charge
to
and start the
and remove the
.
│ 9 ■