Table of Contents
Advertisement
Assembly
Attaching
the Smart Guard
System
To prevent personal injury, always disconnect
plug from power source
before attaching
or
removing the Smart Guard System.
POSITIONING
THE RIVING KNIFE
1. Remove table insert using finger hole.
2. Raise the blade as high as it will go and set it perpendicular
to
table (0 ° on bevel scale) (Fig. 5).
3. Rotate the riving knife release lever 1 clockwise,
so that it
points upward (Fig. 5).
4. Pull riving knife 2 towards release lever to disengage
it from
the pins 3.
5. Slide the riving knife 2 up to its highest position, so that it is
directly over the center of the blade (Fig. 6).
6. Align holes in riving knife with pins 3 and lock the release
lever 1 by rotating it counterclockwise.
Push/pull riving knife to
verify that it is locked in place (Fig. 6).
7. Replace table insert
(Fig. 7).
continued on page 28
_jJ
J
|
2
\
\
26.
Advertisement
Table of Contents
