Table of Contents
Advertisement
Use personal protective equipment when you do servicing and maintenance.
Warning:
Before you do the check, stop the motor and disconnect the power plug from the power supply. Make
Warning:
sure that all drives stop and the machine is cooled down.
Maintenance activities which are not specified in this manual can only be performed by qualified Husqvarna
personnel. Speak to your Husqvarna dealer if machine requires servicing.
Before you do any maintenance work you must read and understand the safety chapter.
Failures due to inadequate or incorrect maintenance can generate very high repair costs and long standstill
periods of the machine. Regular maintenance therefore is imperative.
Operational safety and service life of the machine depends, among other things, on proper maintenance.
The table below shows recommendations about time, inspection and maintenance for the normal use of the
machine.
Operating hours/
time period
12 hours after
repairing
Daily and prior to
starting work
Every 48 hours
Weekly
Every 3 months
Every 6 months
Annually
21.07.2023
6. Maintenance
Inspection points, maintenance instructions
Do a check of all accessible screw connections for tight seat.
Do a check if all safety devices are working adequate.
Do a check of the brush sealing for damages and/or wear.
Do a check of the hose to the dust collector for damage and
obstructions.
Do a check of the electric connections for sediments of dirt or foreign
bodies.
Do a check of the electric motors for dirt and other contaminants.
Do a check of the conditions of the wings /discs.
Remove water from the air tanks.
Do a visual inspection, test and safety checks of remote control
transmitter.
Clean the complete machine with air.
Clean the air filter of the compressor.
Do a check of the buffers of the diamond plates.
Clean the electrical box inside and outside.
Clean the 2 small filters (12, refer to fig. on page 38) of the pressure
difference gauge.
Clean the outside of the Green 6 48/50 battery charger.
Clean the battery contacts and contacts of the remote control
transmitter and charger.
Clean the remote control panel and check print for readability.
Do a check of the HEPA filter. Replace the HEPA filter if it is clogged.
Clean the complete machine with a damp cloth.
Clean the filter of the water separator.
Clean and re-lubricate the chains of the drive system.
Re-lubricate the 8 bearings of the drive system.
Do a check of the chain tension of the drive system.
Do a check of the belt tension of the grinding heads.
Replace the air filter of the compressor.
Replace the filter of the water separator.
Do a check of the sealing of the butterfly valves and Longopack
holders.
Clean the cooling ribs / outside of the blower motor.
Do a full overhaul and clean the complete machine.
Replace the remote control parts by manufacturer.
33
Advertisement
Table of Contents
