Table of Contents
Advertisement
When the battery reaches 45 V an red pop-up is shown, you must stop the machine and load
the battery. If you do not stop the machine, the damage of the battery can occur.
When the voltage reaches 43 V the machine stops.
The machine has a battery monitor at the rear.
Power supply cable operation
This is the normal operation mode for the machine. All functions for normal operation are enabled. Make sure
that the power supply cable has no damages when you operate the product.
The connector is 5 p, 125 Amp. The machine requires 3x400V power supply.
When the main power of the machine is ON, the battery works and the loader is loading the battery.
Do a check of the battery voltage as described above.
Maintenance operation 16 Amp
Connect the 16 Amp connector to the power supply for maintenance operation. The grinding heads do not
work in this setting.
Only drive the machine to and from the work area with the grind heads in the UP position. Safety them with
the quick release pins.
5.3
Battery drive transport to work area
Refer to fig. on page 19.
1. Turn the battery switch to ON (16).
2. Use the ignition key (14) to start the machine.
3. Do a check of the touch screen for errors and warnings.
4. Use joysticks (1) and (9) and push the sign to drive the machine to the work area.
5. When you stop the machine after work, turn the battery switch to OFF and connect the machine to the
400 Vac.
5.3.1
Power supply cable transport to work area
Refer to fig. on page 19.
1. Turn the battery switch to ON (16).
2. Connect the plug of the machine to the power supply 3x400V , 5p 125 Amp
(17).
3. Set the main switch to ON (19).
4. Use the ignition key (14) to turn the machine on.
5. Do a check of the touch screen for errors and warnings.
6. Use joysticks (1) and (9) to drive the machine to the work area.
5.4
To prepare the pre-separator and dust collector
Refer to fig. on page 24.
1. Open the butterfly valves of the pre-separator and dust collector. Pull the levers towards you until they
are in a horizontal position (1).
2. Turn the bag full of dust (2) on itself to obtain a section of coiled bags to be tightened with two clamps
(3).
3. Place the two clamps at a distance of 50 mm / 2 in. between them, then with a pair of scissors cut
between the two clamps.
4. Remove the bag full of dust (2) and pull out a new section of Longopack (4) about 35 cm / 13 in.
21.07.2023
23
Advertisement
Table of Contents
