Table of Contents
Advertisement
•
The compartments that are not dust-tight must be opened with suitable tools and thoroughly cleaned.
•
Operators should observe all safety regulations appropriate to the materials being handled.
•
Never expose the filter cartridges to moisture!
3.13
Grinding safety
•
The grinding heads contain rotating parts, which are protected with sliding covers. Always keep the
grinding heads on the floor while the motor works.
•
The flexible couplings/buffers can become worn out with use, because of this there can be higher
vibrations than normal. Examine the flexible couplings/buffers for deformation and damage before every
use.
•
Do not let the machine rest on the diamond disc or coupling when it is not in use, it causes deformation
to the flexible coupling.
•
Make sure that the brush seals are in good condition, to prevent dust escaping.
•
Make sure the diamond tools (wings/discs/pads) are not damaged or worn out.
•
Always pull out the main plug, set both main switches to off and press the emergency stop button before
you start the replacement of the wings, disks or pads.
•
For replacement of the disks/wings always put on a personal protective equipment.
•
Use the vacuum cleaner to prevent excessive dust.
•
Always put on a protective gloves when handling the grinding disks and wings. The grinding disks and
wings heat up during grinding. There is a risk of getting burned.
•
The machine has rotating parts. Never tilt the grinding heads backwards with a working motor.
•
Be careful when use the machine and pull or let down the machine slowly, big shocks can damage the
electrical parts.
•
Make sure that the floating shrouds are in transport mode when you transport the machine.
3.14
Transport safety
•
Be aware of your surroundings and machine operating level. Do not side hill, do not run on steep incline
(maximum incline 8%). The machine can fall or be damaged.
•
Only load and unload the machine on a levelled and horizontal surface! Steep inclines can cause a
dangerous situation when you lose control over the machine!
•
Remove the dust from the pre-separator and dust collector before the machine is transported.
•
The outside of the machine should be decontaminated by vacuum cleaning methods and wiped clean or
treated with sealant before being taken out of a hazardous area. All the machine parts shall be regarded
as contaminated when removed from the hazardous area and appropriate action taken to prevent dust
dispersal, take precautions to prevent dust from escaping.
•
The weight of the grinding machine is about 3035 kg. Use a flatbed trailer to transport the machine.
•
Make sure that you obey all safety instruction when transport the machine.
•
The lifting eyes can also be used to fasten the machine on a pallet or during transport.
•
Chock wheels for transport and keep control handles in neutral position.
•
Don't leave the machine unsecured in a work area.
•
Park the machine always on a flat horizontal and levelled surface.
•
Make sure that the floating shroud is in transport mode when you transport the machine.
•
Make sure that the electrical cables are disconnected.
•
Store the cleaned and dry machine in a humid free room. Protect the electrical motor from moisture,
heat dust and shocks.
•
Never use the machine for lifting persons or items.
•
Always drive forwards when driving up to a ramp or grade, and backwards when driving off the ramp.
•
Make sure that the machine is not near the edge of the ramp.
•
To lift the product use the BMG-2200 metal palled. To lift the palled you have to use a forklift.
Never allow other persons besides the operator to be transported by the machine.
12
21.07.2023
Advertisement
Table of Contents
