Installer Setting (Unit Registration)
Installer Setting (Add Electricity Meter)
3-6-14
Editing the system confi guration fi le of the touch panel controller by PC
●
Create a indoor unit register file by PC and register it at the touch panel control-
ler.
●
Use the "File Making Sheet" by copying it from the CD-ROM supplied.
●
When correcting the touch panel controller registration data; see par. 3-6-11.
Click "Electricity Meter" button.
b
2
Click "Add" button.
c
"Add Electricity Meter" screen opens.
3
Click "Priority Mode" or "Normal" in the "Setting of
d
Network Priority Mode".
Note
When scanning is performed in the "Priority Mode",
operation of all the units in the system stops. (Recom-
mended setting)
When you do not want to stop operation, perform scan-
ning in the Normal mode.
4
Set "Electricity Meter Start No." and "Electricity Meter
e
End No." using "" or "" button.
5
When the setting is complete, click "Add" button.
f
When the setting is confirmed, click "OK" button.
6
g
7
"Add Electricity Meter" screen closes.
Open "System Form File Making Sheet" file.
●
1
Click "System Form" sheet tab.
a
2
Connect the USB memory containing "Indoor unit reg-
●
istration data" to the PC.
Click "Import Data" button.
b
Select the file to be imported at "System Form" sheet.
●
Note
Display of the screen at file selection is different depend-
ing on the operation software.
Data is imported at "System Form" sheet.
Note
When generating new data from the PC, register it di-
rectly to the file making sheet.
A system composition file is newly created from the
●
PC and is registered to the touch panel controller.
En-35