Setting the temperature display unit
Installer Setting (Function Setting/Temperature Setting)
3-6-17
Setting the settable temperature range
Installer Setting
Setting the settable temperature range
Installer Setting (Function Setting/Temperature Setting)
Notes
• See the table at the right for the tempera-
ture ranges which can be set.
Set temperature high and low limit values
(The temperature cannot be set above
the high value or below the low value.)
Notes
• Set the upper and lower limit temperatures settings performed in the touch panel controller.
*The upper and lower limit temperatures settings from the Standard Remote Controllers are not restricted.
•
See par. "3-3-3" for setting the upper and lower limit temperatures settings to the registered
indoor unit.
●
Set the temperature unit used in the region
where the system is to be installed.
Click "Celsius(°C)" or "Fahrenheit(°F)" button.
a
Click "OK" button.
b
1
2
●
This function limits the width over which the
temperature can be set from touch panel con-
troller to indoor unit.
Click "Change" button of "Temperature Setting".
a
"Temperature Setting" screen opens.
1
● Makes the width the all operation modes same
settable temperature range.
1
Click "All Mode" button of "Temperature Range".
a
2
Select the low limit temperature and high limit temper-
b
ature by clicking "" button.
Click "OK" button.
c
The set contents are entered and "Installer Setting"
3
screen is opened.
Temperature unit
Set temperature (Auto, Cool, Dry)
Set temperature (Heat)
Celsius
Fahrenheit
18 - 30°C
64 - 88̊ F
10 - 30°C
48 - 88̊ F
En-39