Setting the electricity meter by external input signal
Installer Setting (Function Setting/External Input Setting)
Installer Setting (Pulse Value)
Disabling operation setting by external input signal
Installer Setting (Function Setting/External Input Setting)
3-6-16
Setting the temperature display unit
Installer Setting
En-38
●
Set the signal conditions sent from electricity
meter to this unit.
Click "Electricity Meter" button.
a
2
Click "Change" button.
b
"Palse Value" screen opens.
1
Enter the values in the "Pulse Value" using numeric
c
buttons.
Note
• "Pulse Value" : electricity consumption (kWh) per 1
•
Input range :
3
At the end of setting, click "OK" button.
d
"Installer Setting" screen opens.
4
Click "Not Used" button.
a
Click "OK" button.
b
The set contents are entered and "Installer Setting"
screen is opened.
1
2
●
This function limits the width over which the
temperature can be set from touch panel con-
troller to indoor unit.
Click "Change" button of "Temperature Setting".
a
"Temperature Setting" screen opens.
1
pulse sent from electricity meter
0.000001 to 100