Pioneer XC-L7 Operating Instructions Manual page 49

Timer doesn't operate. @ Clock isn't set to the correct current
time.
Power interruption has caused the
clack to be set to the incorrect time
{when display is flashing).
Remote control unit Batteries are exhausted.
doesn't work. A fluorescent lamp is located close
to the remote control unit.
The remote control unit is not pointed
at the signal receiver on the display
unit.
Power won't turn on to System cable connection is incorrect.
the deck or CD receiver.
e@ Reset the clack to the correct current
time. (= P. 15)
Reset the clock to the correct current
time, (se P. 15)
Load new batteries.
Remove the fiuorescent lamp from
the area of the remote control unit.
Point the remote contro! unit at the
remote sensor (located on the right
side of the display unit) when oper-
ating.
Connect the system cable correctly.
@ When the system is installed near a television set, magnetic influence from the speakers may cause the televi-
sion's picture to be distorted. This symptom frequently occurs when using an indoor antenna; in this event,
install an outdoor antenna, or separate the system farther from the television.
@ Static electricity and other outside electrical influences may cause the system to operate incorrectly. in such
cases, unplugging and reconnecting the power cord may help correct the problem.
@ More than one of the same kind of component (CD receiver, MD recorder, or cassette deck) cannot be con-
nected at the same time.
NOTE:
Setting the tuner's frequency interval
FM broadcasts are normally tuned at 50kHz intervals
and AM broadcasts at 9kHz intervals, but this setting
can be changed to 100kHz (FM) and 10kHz (AM) if de-
sired in the following way:
1. Turn the power off.
2. While holding the CD receiver's STOP button de-
pressed, press the display unit's STANDBY/ON but-
ton to ON.
Repeat the above steps to return the tuner's frequency
interval to its original setting.
En <ARB7126> ©