Huawei EchoLife HG8110 Service Manual page 148

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
Prerequisite
l
l
l
Procedure
l
Issue 02 (2011-12-08)
The OLT is connected to the BRAS.
Related configurations are performed on the BRAS according to the authentication and
accounting requirements for dialup users. For details about the configuration, see the
corresponding configuration guide.
The VLAN of the LAN switch port connected to the OLT is the same as the upstream
VLAN of the OLT.
Configure the OLT.
1. Create a service VLAN and add an upstream port to it.
The VLAN ID is 100, and the VLAN is a smart VLAN, VLAN attribute is stacking.
Add upstream port 0/19/0 to VLAN 100.
huawei(config)#vlan 100 smart
huawei(config)#vlan attrib 100 stacking
huawei(config)#port vlan 100 0/19 0
2. (Optional) Configure upstream link aggregation.
In this example, a single upstream port is used. In the case of multiple upstream ports,
upstream link aggregation can be configured. For details, see Configuring Upstream
Link Aggregation.
3. Configure GPON ONT profiles.
GPON ONT profiles include the DBA profile, line profile, service profile, and alarm
profile.
– DBA profile: A DBA profile describes the GPON traffic parameters. A T-CONT
is bound to a DBA profile for dynamic bandwidth allocation, improving the
upstream bandwidth usage rate.
– Line profile: A line profile describes the binding between the T-CONT and the
DBA profile, the QoS mode of the traffic stream, and the mapping between the
GEM port and the ONT-side service.
– Service profile: A service profile provides the service configuration channel for
the ONT that is managed through OMCI.
– Alarm profile: An alarm profile contains a series of alarm thresholds to measure
and monitor the performance of activated ONT lines. When a statistical value
reaches the threshold, the host is notified and an alarm is reported to the log host
and the NMS.
a. Configure a DBA profile.
You can run the display dba-profile command to query the DBA profiles
existing in the system. If the DBA profiles existing in the system do not meet the
requirements, you need to run the dba-profile add command to add a DBA
profile.
Set the DBA profile ID to 10, type to type4, and maximum bandwidth to 100
Mbit/s.
huawei(config)#dba-profile add profile-id 10 type4 max 102400
b. Configure an ONT line profile.
Create GPON ONT line profile 10 and bind T-CONT 4 to DBA profile 10.
huawei(config)#ont-lineprofile gpon profile-id 10
huawei(config-gpon-lineprofile-10)#tcont 4 dba-profile-id 10
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuration
140