Huawei EchoLife HG8110 Service Manual page 152

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
l
Issue 02 (2011-12-08)
by the ONT. In this case, run the display ont capability command to query the
actual capability of the ONT, and then select one of the following modes to modify
the ONT configuration:
– Create a proper ONT profile according to the actual capability of the ONT, and
then run the ont modify command to modify the configuration data of the ONT.
– Modify the ONT profile according to the actual capability of the ONT and save
the modification. Then, the ONT automatically recovers the configuration
successfully.
6. Configure a traffic profile.
You can run the display traffic table ip command to query the traffic profiles existing
in the system. If the traffic profiles existing in the system do not meet the requirements,
you need to run the traffic table ip command to add a traffic profile.
The profile ID is 8, the CIR is 4 Mbit/s, the priority is 1, and packets are scheduled
according to the priority carried.
huawei(config-if-gpon-0/1)#quit
huawei(config)#traffic table ip index 8 cir 4096 priority 1 priority-
policy tag-In-Package
7. Create service ports.
Set the service port indexes to 1 and 2, SVLAN ID to 100, GEM port ID to 1, and
CVLAN ID to 10. Use traffic profile 8.
huawei(config)#service-port 1 vlan 100 gpon 0/1/1 ont 1 gemport 1 multi-
service user-vlan 10 rx-cttr 8 tx-cttr 8
huawei(config)#service-port 2 vlan 100 gpon 0/1/1 ont 2 gemport 1 multi-
service user-vlan 10 rx-cttr 8 tx-cttr 8
8. Configure the queue scheduling mode.
Use the 3PQ+5WRR queue scheduling. Queues 0-4 adopt the WRR mode, with the
weights of 10, 10, 20, 20, and 40 respectively; queues 5-7 adopt the PQ mode.
NOTE
Queue scheduling is a global configuration. You need to configure queue scheduling only once on
the OLT, and then the configuration takes effect globally. In the subsequent phases, you need not
configure queue scheduling repeatedly when configuring other services.
huawei(config)#queue-scheduler wrr 10 10 20 20 40 0 0 0
Configure the mapping between queues and 802.1p priorities. Priorities 0-7 map
queues 0-7 respectively.
huawei(config)#cos-queue-map cos0 0 cos1 1 cos2 2 cos3 3 cos4 4 cos5 5 cos6
6 cos7 7
For the service board that supports only four queues, the mapping between 802.1p
priorities and queue IDs is as follows: priorities 0 and 1 map queue 1; priorities 2 and
3 map queue 2; priorities 4 and 5 map queue 3; priorities 6 and 7 map queue 4.
9. Save the data.
huawei(config)#save
Configure the optical network terminal (ONT) on the Web page.
Layer 3 route mode is used for connecting an ONT to the upper-layer device. IP addresses
of users' PCs are allocated by the DHCP IP address pool on the ONT. PPPoE auto dialup
is performed on the ONT. Parameters of the WAN port must be configured on the ONT.
1. Log in to the Web configuration window.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuration
144