Configuring Gpon Ftth Voice Service (Sip Protocol) On The Nms - Huawei EchoLife HG8110 Service Manual

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
----End
Result
Check whether the telephone functions properly. Connect two common telephones phone 1 and
phone 2 to two TEL ports on the ONT and test the dialing between phone 1 and phone 2. In
normal cases:
l
l
l
l
3.2.5 Configuring GPON FTTH Voice Service (SIP Protocol) on the
NMS
This topic describes how to configure the voice service when an ONT is connected to an OLT
through a GPON port.
Example Network
l
l
Issue 02 (2011-12-08)
NOTE
The terminal IDs A0 and A1 must be consistent with the corresponding configuration on the
MGC.
d. Click OK. In the dialog box that is displayed, click OK. The configurations take
effect without the requirement of resetting the ONT.
The caller hears the dialing tone after taking the phone off the hook.
When the caller dials the telephone number of the callee, the phone of the callee rings
successfully, and the caller hears the ring back tone.
The caller and the callee communicate with each other successfully.
After the callee hangs up, the caller hears the busy tone.
The phones connected to different ONTs can communicate with each other.
The ONT obtains an IP address in DHCP mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Configuration
78