Huawei EchoLife HG8110 Service Manual page 180

EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual
Issue 02 (2011-12-08)
F/S/P
0/1/1
ONT-ID
1
Control flag
activated.
Run state
normally.
Config state
of the
Match state
bound to
actual capability
...//The rest of the response information is omitted.
If the ONT state fails, the ONT fails to be in the up state, or the ONT does not match,
check the ONT state by referring to the above-mentioned descriptions.
– If Control flag is deactive, run the ont activate command in the GPON port mode
to activate the ONT.
– If the ONT fails to be in the up state, that is, Run state is offline, the physical line
may be broken or the optical transceiver may be damaged. You need to check both
the material and the line.
– If the ONT state fails, that is, Config state is failed, the ONT capability set
outmatches the actual ONT capabilities (For details about the ONT actual
capabilities, see Reference of GPON ONT Capability Sets). In this case, run the
display ont failed-configuration command in the diagnosis mode to check the
failed configuration item and the failure cause. Then, rectify the fault according to
actual conditions.
NOTE
If an ONT supports only four queues, the values of 4–7 of the priority-queue parameter in the
gem add command are invalid. After configuration recovers, Config state will be failed.
– If the ONT does not match, that is, Match state is mismatch, the port types and
number of ports undermatch the actual port types and number of ports supported
by the ONT. In this case, run the display ont capability command to query the
actual capability of the ONT, and then select one of the following modes to modify
the ONT configuration:
– Create a proper ONT profile according to the actual capability of the ONT, and
then run the ont modify command to modify the configuration data of the ONT.
– Modify the ONT profile according to the actual capability of the ONT and save
the modification. Then, the ONT automatically recovers the configuration
successfully.
7. Configure a traffic profile.
Run the display traffic table ip command to query the existing traffic profiles in the
system. If the existing traffic profiles in the system do not meet the requirements, run
the traffic table ip command to create a traffic profile.
The profile ID is 9, no rate limitation in the upstream and downstream directions, the
priority is 6, and packets are scheduled according to the priority carried.
huawei(config-if-gpon-0/1)#quit
huawei(config)#traffic table ip index 9 cir off priority 6 priority-policy
tag-In-Package
8. Create service ports.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:
:
: active //Indicates that the ONT is
: online //Indicates that the ONT goes online
: normal //Indicates that the configuration status
ONT is normal.
: match //Indicates that the capability profile
the ONT is consistent with the
of the ONT.
3 Configuration
172