Kenwood TS-790A Instruction Manual page 21

(9) SCAN/TO/CO (Time operate/Carrier operate} key
it [se | L2_ sec) CS Tater)
OFFSET
(47 _set] (3 sev] (6 sEL]
"7: SPS! | 8 TRACE]
'
[ 3 JALeRT)
3 EL.
STEP
a Trace) [a toi
4 | SEL
(12) CLEAR key
i : [a7 sec} (a Tater)
8 (TRACE)
Press the SCAN key to initiate scanning, press again
to cancel scan. For additional information on this func-
tion refer to Section 4-5 SCAN.
Used to select time-operated scanning or carrier-
operated scanning.
Note:
The choice is made during scanning.
Used to transfer a frequency from memory to the
VFO.
Used to enter data into a memory channel.
Used when reentering memory channel data, erasing
a memory channel, clearing scan, when specifying the
channels that will be skipped during scan operations,
or to cancel an entry during direct keyboard entry of
frequency.
21